DataHogs
Connection
DataHog Sockets and connectors – Pin identification
Specification
DataHog2 – resolution and measurement limits
DataHog2 – Potentiometer Inputs
Setup
DataHog2 – switching off unused channels
Instructions to reconfigure a channel previously switched off
DataHog2 setting up relay channels
DataHog2 – differential voltage relay
DataHog2 setting up Digital Channels
DataHog2 & Water Level scaling
DataHog2 – setting up Potentiometer channels
DataHog2 – setting up differential voltage channels
DataHog2 – adding extra software channels
DataHog2 – Changing logging intervals
DataHog2 – setting up logging thresholds
DataHog2 – set up clock, memory & datafile identifier
DataHog2 – memory overwrite changes
DataHog2 – Changing Date & Time
DataHog2 – sensor excitation times
DataHog2 – connecting to a GPRS unit
BAROMETER
DataHog2 – setting up a barometer sensor
DataHog2 – calculating barometer offset for different altitudes
GPRS
Connecting a DataHog to an GPRS unit
LIGHT SENSORS
DataHog – Setting up scaling for an indoor lux sensor
DataHog2 – with SPN1 sunshine sensor
DataHog2 – with CSD3 sunshine sensor
DataHog2 – with BF3 sunshine sensor
DataHog2 – setting up a UV channel
DataHog2 – Setting up a Current Channel for a Light Sensor
DataHog2 – converting light sensor readings to raw current
DataHog2 – connecting a Licor Light Sensor
DataHog2 – Configure for Kipp & Zonen Pyranometers
DataHog2 – Configure a voltage input for a Light sensor
RAIN
DataHog2 Raingauge Event logging
ARG 100 Raingauge wiring instructions
RH & AIR TEMPERATURE
DataHog2 – connecting a PRT1000
SOIL MOISTURE
Please note – tensiometers are no longer available for new orders
DataHog2 setting up Tensiometer channels
DataHog2 loggers and 10cms ECH2O probes
DataHog2 – using tensiometers for irrigation control
DataHog2 – setting up relays for tensiometers
DataHog2 – Hydra probe interface
WATER LEVEL
DataHog – configuration for PTX 1830 sensors
DataHog2 & Water Level scaling – soil
WIND SENSORS
Reconfigure a Wind Speed Relay Channel
DataHog2 – Setting up windspeed channels
DataHog2 – connecting a windvane to a single ended voltage input
Data Output
DataHog2 – Data format from different softwares
DataHog2 Datafile Format & Interpretation
Logger Operation
DataHog2 – switching off for storage
DataHog2 – Check logger internal batteries when using a Mains Hog or Solar Hog
DataHog2 Datafile Format & Interpretation
DataHog2 – Data format from different softwares
How to Measure Current Consumption
DataHog2 – resolution and measurement limits
SOFTWARE
Problems
Tips for solving DataHog communications problems
DataHog2 Digital Input Problems
DataHog2 – Configuration Recovery
DataHog2 – Communications Problems – FAQ
DataHog2 – Automatic controlling software
Tips for solving DataHog Communications Problems